Car Door Edge Guards Clear, 16Ft Rubber Seal Protector U Shape Edge Trim Car Door Edge Protection Fit for Most Car

Soft, pliable, cooperative, easy to cut to size. On a somewhat warm day (for pliability) and with patience and the following method, it fit/butted up perfectly, along a ridge/rim on the inside of the door. I trimmed to length & fitted the product along the entire edge, (I put red strip on the inside.) Started at the top, used my fingernail to lift a tiny section of the soft, inside edge; gently pulling off the removable red strip on the adhesive; an inch or two at a time. (Only the inside portion of the strip has adhesive.) Then I applied even, medium pressure on both sides and the turned, outside edge of the strip; in a pinch/press (no sliding/stretching) motion- again a few inches at a time. I was careful to neither stretch or scrunch the length of the strip at any time. The product is almost clear, but has an ever-so-faint violet tinge to it in some lighting; but it was not a deal breaker for me. It attached firmly and evenly; along the inward and outward curves of the door. It’s been on for a few weeks and car washes; It’s been really hot, and has stayed attached. Some moisture does seep in under the outside edge; and a neat, hairline of fine dirt accumulates along the outside edge. Since the dirt is about the same color as our beige car it’s not obvious. BTW I put a very similar product on our older car doors over 10 years ago. Although it also gets moisture underneath, and the same hairline of fine dirt accumulation, it has remained in position through numerous car washes, rainstorms, wet roads, severe cold and heat; AND has prevented damage to our other car. I can’t speak from experience; but I imagine that this edge strip is removable, if needed, since it remains in a somewhat pliable state.